Greetings all,
I have an Aira System 1, TR-8 and TB-3 hooked up to my pc via usb. Connected to Waveform through midi. I am using ASIO. I stumbled upon it once before but am unable to get there again. How do you enable the start/stop signal to tie into recording? Any guidance would be appreciated. Thank you all.
Waveform Pro 11 Midi start and stop
-
- KVRer
- 3 posts since 8 Feb, 2023
-
- KVRer
- Topic Starter
- 3 posts since 8 Feb, 2023
Update: I figured it out.
-
Peter Widdicombe Peter Widdicombe https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=336849
- KVRian
- 1205 posts since 29 Aug, 2014
For those that are curious - what was the tweak in the end? Waveform or MIDI setting on an external device?
(ASIO is audio only, so presumably that wasn't it...)
(ASIO is audio only, so presumably that wasn't it...)
Waveform 13; Win10 desktop/8 Gig; Win11 Laptop; MPK261; VFX+disfunctional ESQ-1
-
- KVRer
- Topic Starter
- 3 posts since 8 Feb, 2023
I apologize for not seeing this for a year. I don't remember what I did at the time but ran into same issue the other day. I didn't realize there were selections for the midi outputs to receive start/stop signals. Everything runs over usb and it seems to work now. I switched back to windows audio because AISO kept stealing audio control from my pc lol. I need to get more familiar with ASIO though.