Arturia MiniFuse1 and Beyerdynamic DT 880 250 Ohm

[Igro]

Hi. Does anyone have this combo? Does the Minifuse1 nicely drives the 250 Ohm DT 880? Also, i have connected my FLKey Mini to MiniFuse1 USB port. Thank you.

[Igro]

Now I got this headphones and have to crank the MiniFuse to the max to hear it ok. So this inteface is not suitable for such cans, as this might lower the quality. I have to search for higher impedance interface now.

[BertKoor]

You could have known... Page 38:
https://dl.arturia.net/products/minifus ... 0_0_EN.pdf
According to my calculations it provides a dinky 18mW into 250Ω.
(137mW into 33Ω gives 2.13V which into 250Ω is 8.5mA and thus 18mW)

NB: a matching impedance isn't all you need. My interface provides enough juice, but it has clearly audible harmonic distortion. Just consider getting a decent headphone amp for your cans to solve this once and for always.

[Igro]

Thanks BertKoor. After a long search I found that Audient id4 mk2 should do the job.

[danielh02]

Thanks BertKoor. After a long search I found that Audient id4 mk2 should do the job.

I have the the Audient iD14 and those headphones and the output is fine.

[Igro]

Thanks BertKoor. After a long search I found that Audient id4 mk2 should do the job.

I have the the Audient iD14 and those headphones and the output is fine.

Thanks for the reassurance. (As I'm still waiting for the new device).