Different channels on different channels ))

[andyjazzy]

Good luck to all. Can someone tell me how to implement this in FL Studio: so that one instrument (or sample) has the right channel going to one mixer channel, and the left channel to the other? That is, as a result, there are different effects on each of the LP channels. Thank you.

[mjolnir]

if you use the step editor, do panning in there, and then press Ctrl-L to assign that instrument to it's own mixer channel.
select the next instrument and repeat.

[andyjazzy]

if you use the step editor, do panning in there, and then press Ctrl-L to assign that instrument to it's own mixer channel.
select the next instrument and repeat.

Thanks, but I mean ONE instrument (or ONE sample) with different outputs. Duplicating two tools is also not good.

[andyjazzy]

Thanks, I figured it out.
I send it on the mixer from the first channel to channels 2 and 3 and turn off the signal to the master.
On channels 2 and 3, I make the balance to the end left and right, respectively.