FH-2- Problem receiving the clock with Digitakt

[Funambule1412]

Hello, I have a problem with the FH-2 module that I just bought second-hand. It seems to be in perfect working order except that it cannot identify the clock that I send with my Digitakt Elektron.

When I plug it into the USB A port, the Clock status on the FH-2 screen always shows 'None', and a message at the bottom of the FH-2 screen flashes very quickly and says 'Clock Ch1 or 2 CC 100' with CC values that vary between 70 and 100... As if it could not interpret the clock message well.

Could this be a bug in the module? I was able to contact someone who has the same configuration and it works perfectly for them.
I should point out that the Digitakt is well set up to send the information correctly, I used to use a Hermod Squarp with it and it worked perfectly.

Thank you for helping me. I would like to point out that I have put the latest update on it.

Best regards,
Colin Vincent

[os]

I replied to your duplicate post on Modwiggler.