KVR Audio

Glassback · Post by **Glassback** » Sat Feb 05, 2005 9:22 pm

Shite - now what?
Try 2.2 or revert to 1.8?
Decisions, decisions.

ceenda · Post by **ceenda** » Sat Feb 05, 2005 9:25 pm

Well, I don't think installing the 1.8 will do any harm. Just make sure you run the un-install for whichever version you are running currently.

I'd say uninstall v2 and then install v1.8 and see if it works for you. If that doesn't work, it's no problem to uninstall v1.8 and then go back to v2 again.

I switched between the 2 various times whilst trying to work out what was going wrong.

fake · Post by **fake** » Sat Feb 05, 2005 9:53 pm

Make sure you have any inputs disabled in the asio4all panel as this cuts down on the latency problems.

The soundcard will show up as wdm as that is what native routine windows uses to communicate with, so thats ok.

You can also have both versions installed.

May help!

fake

Glassback · Post by **Glassback** » Sat Feb 05, 2005 10:03 pm

OK, took the plunge (just before fake posted) and uninstalled v2 in favour of 1.8.

Instantly noticable improvement in the performance of the tune that I'm currently working on.

ceenda - thanks for the good advise.
krim, fake and opi - thanks also.

(fake - I've got the 'disable input' button checked - I asume that's what you meant?)

I'll give it a test over a couple of days, see how it performs over time.

fake · Post by **fake** » Sun Feb 06, 2005 12:37 am

Yep, thats the one.

There was a thread a while ago about it with some comments from the guy who developed it. He recommended that you disable the inputs as it works better.

fake

Glassback · Post by **Glassback** » Sun Feb 06, 2005 12:49 am

fake wrote:

Yep, thats the one.

There was a thread a while ago about it with some comments from the guy who developed it. He recommended that you disable the inputs as it works better.

fake

Which begs the question "so why put 'em there then?"

ObsoleteAcc99 · Post by **ObsoleteAcc99** » Sun Feb 06, 2005 8:10 am

[DELETED]

Glassback · Post by **Glassback** » Sun Feb 06, 2005 10:35 am

ttoz wrote:
Kriminal wrote:Looks like your Audigy isnt using the ASIO, its using WDM...that doesnt look right, they are diff arent they? I dont know much, and im prob wrong, but it looks iffy to me.
it's right. WDM stands for windows driver model. Asio 4 all can only provide asio (audio stream input output) to wdm compliant sound cards.

what i think he might need to do is raise his ks buffers to 3.

he's very grateful for that tip.
he thanks you very much.

Orion and Asio 4 All