There may be other ways but here is what I do:pquenin wrote:I also have a question : I wan't to use Reason as a rack of synths, and sequence them from Mulab. How do you do to tell Mulab that Track x (or Rack x)in Mulab must send his midi events to Synth y in Reason ? It's possible in Tracktion but I don't see something like this in Mulab.
In MuLab I add in the MPA a ReWire > Reason and connect the first Mix L+R output to Rack 1.
In Reason expand the "Hardware Device" (First device on the top) and press the button "Adv. Midi Device"
For each BUS [ A B C D ] you can have up to 16 Reason Synths/Devices to control.
Go to each Channel Button Selector and Pick your device for that MIDI channel.
In MuLab than select as you did the specific channel for each Rack equal to the channel you have just selected in Reason and that Reason Device will play:
[Rack 1 = Ch 1] = [Reason Ch 1 = Thor or something else]
[Rack 2 = Ch 2 or 3 or ....] = [Reason Ch 2 or 3 or... = whatever you have selected there]
For now run your devices through the Reason Mixer and let the mixer be your audio output as usual.
I hope is not confusing.
The thing is that I had to choose as a Target a MIDI Outputs and a Port in my MuLab Racks in order to have everything working without crashes.
Anyhow I am waiting for someone else to come up with a better way or the "Right Way" because I am not sure this is the intended one from Jo.
The beauty of MuLab vs. Tracktion is that Tracktion will steal from you a channel for every single device in Reason even if it is a simple effect in the chain and it is quite easy in Reason to reach 64 devices as you know.
For example if you have a Combinator with 10 devices Tracktion will allocate 10 channels out of a BUS to the Combinator while MuLab will just need a single channel for it. At least as far as I understand Tracktion.
This is very well implemented here.
