Zebra 3.0 released

[eclipse_soundlab]

Is there any way to make 1 affect phase of individual partials of 2 in spectrum OSC mode?

[Urs]

No, there isn't. Been thinking about it, but it seems to me that this would add a vast layer of complexity for possibly little returns... what do you think?

[eclipse_soundlab]

The plot domain already shows a "ghost" image of the partials, so that would make sense (and not cause confusion)

However, I wouldn't want to miss out on one OSC FX to modify phase.

The curve axis should have a separate Phase block to edit (only in spectrum mode)
(image)

[eclipse_soundlab]

But thinking about it now, there would be greater benefits if the phase could be modulated separately, on a dedicated axis, rather than on the same mod path as the waveform.

[Urs]

One day maybe we start a set of experiments for phase manipulation. See how much value it has, for how much effort is needed.

I would much rather put this in an OscFX than make users edit two Spline Curves in Spectrum mode.

[pdxindy]

Is there any way to make 1 affect phase of individual partials of 2 in spectrum OSC mode?

Do you mean that 1 would affect only curve 2 and not any of the other curves that might be playing?

[eclipse_soundlab]

Is there any way to make 1 affect phase of individual partials of 2 in spectrum OSC mode?

Do you mean that 1 would affect only curve 2 and not any of the other curves that might be playing?

no. in first example phase status is determined by mapomatic curve knob state/knob modulation. so waveform axis modulation dont change phase modulation because its done by mapomatic osc fx and mapomatic curve knob position.