"MIDI mapper"...erm, help?

[headquest]

Can nobody else help or advise about this?

Not only will T2 not allow for controller mapping with the Ozonic, but it won't now allow me to use it for note entry either... when I click on the Ozonic MIDI icon to drag in in as an input, it tells me that the Ozonic is being used as an external controller, so can't receive normal MIDI messages

I posted about this on the Mackie site, asked M-Audio, posted on the hardware section of the general KVR forum... can nobody help?

[haydxn]

you probably have it set as an MMC controller in the TIMECODE button; check that button and make sure that it's not set to RECIEVE MMC FROM DEVICE->(ozonic input).. set it to none.

also, check the control surfaces section on the settings page and make sure that everything there is set to none also.

hopefully that should free up the input again

[headquest]

Thanks for the response...

... but all those things were already set to "none"...

[headquest]

Just tried the Ozonic back in T1.6 to see if it would work... and as a basic keyboard for my VSTs it works just fine still (which is one relief, at least).

I don;t know if this may help the diagnosticians get any better understanding of how the Ozonic is interacting with Tracktion?

Otherwise I think I'm fresh out of ideas now...