KVR Audio

heffus · Post by **heffus** » Thu Nov 10, 2005 3:58 pm

anyone know how to change the command line parameter for vsthost.i'm trying to put it into slave mode. i go to the properties dialog but i don't know where the command kine is.

heffus · Post by **heffus** » Thu Nov 10, 2005 3:59 pm

that' command line, not kine.

sboullion · Post by **sboullion** » Thu Nov 10, 2005 5:39 pm

Create a shortcut for VstHost.Then right click on the shortcut,then where it says "Target" type "/slave" after the last end quote.Hit apply and You're done.
Hope I explained it well enough

heffus · Post by **heffus** » Fri Nov 11, 2005 4:04 am

thanks for the help but its not working.when i hit apply i get a message that the file name in the target box is invalid.

sboullion · Post by **sboullion** » Fri Nov 11, 2005 6:28 pm

Did You make sure You put it AFTER the end quote?And make sure You use a forward slash (/).

Edit:I just realized,You have to make sure You put a space between the end quote and the forward slash.

Should look something like this:

"C:\Audio\Vst Host\vsthost.exe" /slave

vsthost question