LiveLab.dk

DarkStar · Post by **DarkStar** » Mon Nov 21, 2005 5:47 pm

[LiveSlice v1.22, energyXT host]

Changes (e.g. loading a new loop) made in LiveSlice were not detected by the host as changes, so I could close the host without being prompted to save the song.

I don't know how this is meant to work, so it might be a host problem?

R.A.W. · Post by **R.A.W.** » Mon Nov 21, 2005 6:34 pm

this is a host issue, i loaded synth1 into eXT demo, saved the song, changed a value in synth1 and when i closed, no prompt was opened.

fabi · Post by **fabi** » Mon Nov 21, 2005 6:39 pm

can confirm r.a.w's version of that one. been having that quite a lot in eXT... never really bugged me, though.

DarkStar · Post by **DarkStar** » Mon Nov 21, 2005 6:44 pm

Ok, I'll post over there .
Thanks

ohm · Post by **ohm** » Mon Nov 21, 2005 6:49 pm

I just tried loading a gui'less VST, saving, changing parameters and then closing - no save prompt. It's definately a host limitation.
I can't even do an internal check for changes, because there is no way I can stop the host app. from closing down.

LiveLab.dk

KVR Audio

BR? - LiveSlice changesx not notified to host