Hi all, hope someone can advise. I have done a piano part for a full song. This is in different events for verse/chorus etc. What I have noticed is that some parts - say the verse - are a lot louder as a whole than other parts. What I want to do is balance the whole
piano part. I can use the midi/velocity option to turn down or raise certain bits of the piano piece but, as I said I want the whole part to have a single peak.
Any ideas on how to do this?
Cubase SX3 - balancing volume of a track. Help?
-
- KVRian
- 541 posts since 19 Jun, 2002 from London, UK
Compressor? If the imbalance is relative, that is
Otherwise just use mixer automation - switch on the "W" button in the mixer, move the fader while the track is playing, and when you're done, turn off the "W" and turn on the "R".
Otherwise just use mixer automation - switch on the "W" button in the mixer, move the fader while the track is playing, and when you're done, turn off the "W" and turn on the "R".
Three shall be the number of the counting
And the number of the counting shall be three.
And the number of the counting shall be three.
-
- KVRist
- Topic Starter
- 355 posts since 21 May, 2006
No, compressor no good as imbalance aint relative.Trojan Badger wrote:Compressor? If the imbalance is relative, that is
Otherwise just use mixer automation - switch on the "W" button in the mixer, move the fader while the track is playing, and when you're done, turn off the "W" and turn on the "R".
Automation? Bit messy that. Cant help think there must be some logical editing way to do it?
Any advanced sx users around?
-
- KVRAF
- 9064 posts since 1 Aug, 2003
why not use several channels, one for each "event"?BoyWonder wrote:Automation? Bit messy that.