KVR Audio

Koe:rade · Post by **Koe:rade** » Thu Feb 07, 2008 1:30 pm

Hi,

I'm thinking of using a feedback destroyer in my vocal effects chain.

What would be the best way to use it to eliminate any feedback caused by my effects?

Is it as simple as this:

Mic -> FX -> Feedback Destroyer -> Mixer

??

Any advice would be hugely appreciated.

Thanks,
Koe.

C00kie · Post by **C00kie** » Thu Feb 07, 2008 2:01 pm

Still struggling with the same old issue??

And yes: it's that simple... Maybe you get better results if the feedback killer is put in the chain directly after the mic. You'll have to experiment at bit what works best.

Koe:rade · Post by **Koe:rade** » Thu Feb 07, 2008 2:06 pm

Haha... Yes, that's right!

Thanks a lot. I'm glad something is (relatively) easy!

Koe.

C00kie · Post by **C00kie** » Thu Feb 07, 2008 2:14 pm

I've overseen one tiny detail: the feedback killer probably works with line signals while you use a mic as the input. Just looked up the TC Electronic Fireworx you use, and it's also supposed to work with line levels.

Do you use a mic preamp inbetween the mic and the effects unit, or is it inserted in the signal chain at the mixer?

Koe:rade · Post by **Koe:rade** » Thu Feb 07, 2008 2:24 pm

Ah... Forgot that detail. The mic is hitting preamp before any FX. As long as the mic is hitting the preamp before anything else this should be fine right?

C00kie · Post by **C00kie** » Thu Feb 07, 2008 2:32 pm

Koe:rade wrote:As long as the mic is hitting the preamp before anything else this should be fine right?

Correct indeed

Koe:rade · Post by **Koe:rade** » Thu Feb 07, 2008 2:35 pm