KVR Audio

LittleStudios · Post by **LittleStudios** » Sat May 21, 2011 9:07 pm

I'm developing a trance gate plug-in the has an attack and decay for each step of the gate. This might be tough to describe, but here goes. In regards to the attack time of the step, would it be better to have the attack time be prior to the start of the step, thus making the peak volume at the start of the step. Or would it be better to have the volume ramp begin at the start of the step and peak volume land somewhere in the step timeline? If this question doesn't make sence, I'll work on a sketch and upload it.

manducator · Post by **manducator** » Sat May 21, 2011 9:12 pm

The second option makes more sense to me.

LittleStudios · Post by **LittleStudios** » Sat May 21, 2011 9:16 pm

I'm trying to get others thoughts, because the code for the two different options are quite different. I'm trying to avoid starting and then realizing the other way was probably a better choice.

peterdh · Post by **peterdh** » Sun May 22, 2011 12:20 am

manducator wrote:The second option makes more sense to me.

+1
I also have a tip for you: Look at the free Stormgate 1 plug-in, expand the possibilities

and make it work in every DAW

Developing a Trance Gate, need musicians thoughts