KVR Audio

lfm · Post by **lfm** » Tue Sep 11, 2012 1:56 pm

Hi

I refretted a guitar some years ago but never bothered to get up the best finish on guitarneck below binding after that. It became a little satin on spots where sand paper happend to touch.

What is the process and what you need?

Thanks.

tapper mike · Post by **tapper mike** » Tue Sep 11, 2012 3:57 pm

start over from the top. Strip it all down and start again because it will never be even. Or accept that the uneven finish is a sign of character and live with it.

Hink · Post by **Hink** » Tue Sep 11, 2012 4:07 pm

would you like this moved to the diy forum?

lfm · Post by **lfm** » Tue Sep 11, 2012 5:29 pm

Hink wrote:would you like this moved to the diy forum?

Good idea, I didn't think of that.
Thanks.

Hink · Post by **Hink** » Tue Sep 11, 2012 5:45 pm

okay, I sent a request to the mods and typically they are right on top of it. I'm one of the mods of the DIY forum but I have no powers outside of the DIY forum, I can move threads from the diy forum to another forum but in cases like this I can't move them to the diy forum.

I wish I could offer you advice on refinishing your guitar but painting and finishing is me weakness

DuX · Post by **DuX** » Tue Sep 11, 2012 6:25 pm

I thought you were asking if one had to be high to get the high gloss finish on a guitar...

lfm · Post by **lfm** » Tue Sep 11, 2012 9:08 pm

DuX wrote:I thought you were asking if one had to be high to get the high gloss finish on a guitar...

I certainly hope not.

I only use music for that.

High to get that high gloss finish on guitar?