ES3 power supply adaptor

[tiego]

I finally received my ES3 just now
the ES site states that i can supply +/-15v instead of 12V with a suitable adaptor cable....
problem is that I do not use any Branded cable in my 15V system
I have a really good (power one ) 15v supply with multiples sending +15/-15/0V (com) thru cables that I solder myself;
now in the doepfer plug there is 16 connectors with no less than 3 ground connections....

should I solder -15V to the red stripe cable ;then connect the PSU COMmon to the 3 next cables then +15 to the 5th (from the bottom up)? Or do i need extra regulators?
thanks for your help
tiego

[os]

The cables on the Doepfer connector are actually in pairs, so it's 2 at -12V, 6 at ground and 2 at +12V.

You can feed the ES-3 directly with ±15V.

[tiego]

thanks for the answer

meaning the 2 bottom paralell connectors are -12V etc....

"You can feed the ES-3 directly with ±15V."

meaning i replace ALL those -12V /OV/+15V or should I solder my 3 cables elsewhere?

[tiego]

done
the pairs are "multiples" indeed so doesn t matter i cable them all
thanks os
that thing is fun