Anyway to make the signal 100% stereo in zebra 2?
-
- KVRist
- 85 posts since 7 May, 2013
In ableton there's the utility plugin that you can make the signal 100% different on the right and left by raising the width to 200%. I know a lot of modules have a width function so I was wondering if I have my patch done, but then I want to make the whole thing 100% stereo, is there a way to do it? If so how?
-
- KVRAF
- 3817 posts since 8 Mar, 2006
hmm... I think you are confusing stereo VS mid-side mode. (you want to push the sides more which results in a wider "stereo" image)
Didn't experiment emulating mid-side in Zebra before so I don't really know if it's possible.
Didn't experiment emulating mid-side in Zebra before so I don't really know if it's possible.
-
- KVRAF
- 4197 posts since 23 May, 2004 from Bad Vilbel, Germany
Zebra2 is already "100% stereo" if you want it to be... but it doesn't include an extra "stereo-widening" effect. Tip: Try adjusting those pan pots (in the central 'mixer' section) if your patch uses multiple lanes.
-
- KVRist
- Topic Starter
- 85 posts since 7 May, 2013
yes that's exactly what i mean, can you affect mid-side in zebra2 somehow?3ee wrote:hmm... I think you are confusing stereo VS mid-side mode. (you want to push the sides more which results in a wider "stereo" image)
Didn't experiment emulating mid-side in Zebra before so I don't really know if it's possible.
-
- KVRAF
- 3817 posts since 8 Mar, 2006
no such processor but you can fake the effect.
Try on a simple patch 1st:
-load/enable 2 OSCs both running the same wave.
-pan one L and the other R
-activate hardsync on one of them (doing that will automatically flip the phase of the wave)
-adjust osc phase of more/less cancellation resulting to wideness
Try on a simple patch 1st:
-load/enable 2 OSCs both running the same wave.
-pan one L and the other R
-activate hardsync on one of them (doing that will automatically flip the phase of the wave)
-adjust osc phase of more/less cancellation resulting to wideness