Organ3 and rotary

[mchoffmann]

Hi there,
ECS seems to be too easy for me.....
I am trying to set up the rotary so it switches from slo to fast by modWheel action.
MW 0 -> slow
MW 100% -> switch to fast

I managed to get it switched to fast but cannot figure out the other half.
I am able to do that on SampleTanks organ but i would like to do that with DaOrgan as well.
Any suggestions?

Regards
Marc

[Peter from LinPlug]

Hi Marc,
when assigning any CC (including Mod Wheel) you can switch Slow -> Fast and Fast -> Slow with it, I double checked and its fine. There is only one thing worth noting (from the manual:)

NOTE: When using ECS to automate the Slow/Fast switch make sure to use a “Switch” type Controller to actually switch between Fast and Slow using the Acceleration parameter. If you apply a “Continuous” type Controller like a dial or slider, the speed will adjust exactly as you move the Controller (ignorning the Acceleration parameter)!

Hope this helps,
Peter