Hi everyone, first of all I want to apologize for the stupid question but I'm a complete idiot when it comes to these things and I don't want to break anything...
I converted my Minibrute into an SE version via the sysex send described here:
http://hackabrute.yusynth.net/index_en.php?&arg=2
So far, so good - no problem. I also printed out the overlay that was so conveniently provided but now I have no clue how to remove the Brute's knobs without breaking it. Would anyone be so kind and point me in the right direction? Is this even something I can achieve by myself or do I need serious technical or even soldering skills to succeed?
Thanks in advance.
Minibrute knob replacement
-
- Beware the Quoth
- 35449 posts since 4 Sep, 2001 from R'lyeh Oceanic Amusement Park and Funfair
Unless the knobs have grub screws holding them on, (which you'd see) they'll probably just be press-fitted, possibly onto a D-shaped shaft. Carefully prise them up under the edge with a flat-bladed screwdriver or similar. Work round it, bit at a time to begin with, until its lifted up a bit. Do it carefully so you dont scratch the synth.
Or try what this guy does.
Or try what this guy does.
An idiot on Set Theory:
"In some cases there is an object called red that contains everything that is red. In much the same way a pot is a plate."
"In some cases there is an object called red that contains everything that is red. In much the same way a pot is a plate."