Spark 2 latch filter
-
- KVRist
- 443 posts since 10 Mar, 2005
Hi the latch filter on spark 2 seems to be completely broken.I thought it was supposed to hold the filter setting. Does not do anything at all now. I have win 7 64 and 2.3.079 of spark
-
- KVRist
- Topic Starter
- 443 posts since 10 Mar, 2005
-
- KVRist
- Topic Starter
- 443 posts since 10 Mar, 2005
There is a bypass switch for the filter that is on by default seems like. Switch it off and everything works ok
-
- KVRist
- 256 posts since 1 May, 2014 from SW Wisconsin
For me as well, but on the Roller X/Y pad. That is SUPPOSED to only activate when pressing on the X/Y pad, but now it is ALWAYS active, which is what's supposed to happen with the Slicer modes.
It's like the Spark 2 software is just breaking down over time.
I am on Win 7 64 bit, and my Spark 2 software is up to date, as is my CDM controller.
@boombaxx ... where is this bypass switch that you speak of. perhaps this is the problem for me as well. thanks
It's like the Spark 2 software is just breaking down over time.
I am on Win 7 64 bit, and my Spark 2 software is up to date, as is my CDM controller.
@boombaxx ... where is this bypass switch that you speak of. perhaps this is the problem for me as well. thanks