Hello, this is the first time I have posted here having just downloaded a trial version of MLab v.8
I downloaded the zip file to an external SSD drive and ran the install from there. There aren't too many options regarding audio engine setup so its a simple procedure thankfully. I selected in this order --
ASIO
UA-25
44100 Hz Sample rate / couldnt set any other value there but 44100 is fine
Set Outputs / OK
Audio Processor Threads / defaults to Auto
CPU Limit / defaults to OFF
No sound! Can anyone help? Is it because the program is not installed on the C drive perhaps?
Thank you.
AUDIO INTERFACE NOT RESPONDING
-
VirtualProducer VirtualProducer https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=462163
- KVRer
- 2 posts since 13 Apr, 2020
-
VirtualProducer VirtualProducer https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=462163
- KVRer
- Topic Starter
- 2 posts since 13 Apr, 2020
Hello and thanks for responding. I use Windows 8.1 64 bit and d/loaded MuLab 8.5.4 for Windows (64 bit) I will try to run the installer again and see if the problem is still the same.