KVR Audio

elfan · Post by **elfan** » Sat Sep 11, 2004 4:24 am

I was thinking of syncing Logic to Cubase through midi clock/SPP. This seemed to work until I discovered that Logic only seems to sync to tempo and start/stop, not the actual song position. Only when I restart Cubase, Logic will refresh its position. If I set up a loop in Cubase, Logic will not follow that loop, but instead it just keeps on going forward until I stop and start again, then it falls back into line.

Anyone know anything of this problem? Am I doing anything wrong? What setup should I be using? Currently, I am just using Auto enable external sync so Logic discovers incoming midi clock signals automatically.

Thanks!

//Tomas

DevonB · Post by **DevonB** » Sat Sep 11, 2004 6:07 am

PURE guessing here, but try MTC instead. I believe that should give song position. It's something I've never needed to look into, so forgive me if it's wrong.

Devon

elfan · Post by **elfan** » Sun Sep 12, 2004 5:18 pm

Okay, I'll check it out. Thanks

.

//Tomas

Syncing Logic to Cubase