Hello,
Has anyone else tried getting the Michigan Synthworks f8r to work with the Disting ex. I have spent the last hour following directions and maksing sure everything is connected correctly. I currently cannot get it to work.
It is really vague for the f8r which address it sends on and I tried all of them that it shown in the Arduino Code. (Looks like no dip default to (0x34)?
If someone knows how to integrate... please help!
Disting ex -> i2c -> f8r setup (can't get it to work)
-
- KVRist
- Topic Starter
- 268 posts since 2 Aug, 2006 from Chicago, IL, USA
-
- KVRian
- 1410 posts since 22 Mar, 2002 from UK
Have you reflashed the F8R with the i2c code enabled? IIRC it ships with it disabled.
MSW have a disting EX - you might like to ask them for help too.
MSW have a disting EX - you might like to ask them for help too.
-
- KVRist
- Topic Starter
- 268 posts since 2 Aug, 2006 from Chicago, IL, USA
I asked them … they just said”put it in leader mode” which was the first thing I did. I checked the connections and everything is lined up, but see no i2c data coming into it
-
- KVRian
- 1410 posts since 22 Mar, 2002 from UK
Do you have the pull-up resistors enabled at one end or other?
-
- KVRist
- Topic Starter
- 268 posts since 2 Aug, 2006 from Chicago, IL, USA
Yep … flipped the switch as specified. Nothing. I also tried the midi config and see no Midi data coming through either.
-
- KVRist
- Topic Starter
- 268 posts since 2 Aug, 2006 from Chicago, IL, USA
Looks like it is a broken f8r. Returning to MSW and seeing if a new one bodes better results.
Thanks for helping as well to isolate it!
Thanks for helping as well to isolate it!
