I noticed this a few days ago; when sliding to a different pitch in Studio One 5 using MPE and releasing the note (that was the end of the glide), the pitch reverts down. This is specific to Studio One, it doesn't occur in either Bitwig 4.2.3 or Waveform 12. BTW, the controllers are two Seaboard Blocks (though the error still happens if only one Seaboard Block is used). Has anyone else had something similar happen? Are there solutions or work-arounds for this?
I've included the Studio One file (zipped) below so you can see the error. I have an MP3 of the bug in action so you hear it as well, but apparently KVR doesn't allow for MP3 attachments.
Apparently, Studio One doesn't seem to recognize the "lift" of the "5 D's" of MPE either. I have yet to hear it enacted (in the current sense) on any of the patches that utilize lift as a modulator (and in Equator 2 there is a visualization GUI that shows that lift is truly being ignored. Neither can one hear it in Strobe 2 or Cypher 2.) I have reported both these issues to Presonus. While I was directed to watch for the next update, there is no schedule for when the next update will be.
MPE Bug(s) in Studio One 5
-
- KVRian
- 973 posts since 24 Oct, 2006
You do not have the required permissions to view the files attached to this post.
Last edited by dlandis on Thu Apr 28, 2022 11:03 pm, edited 1 time in total.
“Madness, as you know, is like gravity: all it takes is a little push.”
-
- KVRian
- Topic Starter
- 973 posts since 24 Oct, 2006
If anyone has an MPE capable controller, would that person check to see if: 1) on patches with long releases, if the pitch attempts to revert back to the original pitch after gliding to a different pitch and 2) if lift is registering at all in Studio 5 for you. Thanks!
“Madness, as you know, is like gravity: all it takes is a little push.”