Mono Stereo Question- Big Sky

[Cliveluis]

another Mono stereo question..

Thing is , in my church there are only xlr combo mono outs (no control over mixer)

So Is it ok if I use stereo outs from my Big Sky and plug into 2 of those mono outputs ?
I plan to use two TS cables for that

Alternatively
Before sending to XLr outs , If I send big sky stereo outs to a mini mixer(personal) and hard pan both left and right , would it make a difference?

[Funkybot's Evil Twin]

another Mono stereo question..

Thing is , in my church there are only xlr combo mono outs (no control over mixer)

So Is it ok if I use stereo outs from my Big Sky and plug into 2 of those mono outputs ?
I plan to use two TS cables for that

Alternatively
Before sending to XLr outs , If I send big sky stereo outs to a mini mixer(personal) and hard pan both left and right , would it make a difference?

This probably belongs in the hardware forum, but the Blue-Sky has two mono ins and two stereo outs right? It can take a single mono input if that's all you need, and then send out a stereo reverb signal from that mono input. It can also take dual mono input signals and internally hard pan them (one input is L the other is R) to provide a stereo output.

Shouldn't be an issue. Should also have no problems with line level signals.

[pekbro]

Using only one input sets it (BigSky) to mono mode, stereo requires stereo input, pretty sure. Dunno about the Blue Sky.

*Anyway, I don't really get the OP's question, it sounds like you want to run 2 outputs into 2 outputs,
that you cannot do. The Big Sky outputs can go into 2 inputs of course.