guys, im too stupid to find it i guess? i didnt read the manual fully yet but i couldnt find it while going through a bit generally, is there no balance control to e.g. reduce the mono signal and push the stereo signal?
there are various ways to make the sound more stereo but how can i reduce the mono signal?
thx
Nugen Stereoizer - Balance of Stereo/Mono Signal?
-
- KVRAF
- 9674 posts since 5 Aug, 2009
DAW FL Studio Audio Interface Focusrite Scarlett 1st Gen 2i2 CPU Intel i7-7700K 4.20 GHz, RAM 32 GB Dual-Channel DDR4 @2400MHz Corsair Vengeance. MB Asus Prime Z270-K, GPU Gainward 1070 GTX GS 8GB NT Be Quiet DP 550W OS Win10 64Bit
-
- KVRAF
- 3709 posts since 21 Nov, 2015
If I am not mistaken its indeed a stereo - widener only. So you would need their mono - filter instead.
You can be creative in any right place on Earth, and not only in the wealthiest cities. Bring the world feelings from everywhere, and not only feelings of capitalistic or jail environment.
― Aleksey Vaneev
https://linuxdaw.org
― Aleksey Vaneev
https://linuxdaw.org
-
- KVRAF
- 6282 posts since 8 Jul, 2009
Stereoizer creates (or enhances) a stereo signal, from a mono or stereo input. There is no control over the levels of the stereo and mono signal. You'd need to process the output of Stereoizer with an MS tool to allow you adjust the mono component.
#NONFR Check out my music at Bandcamp 
Free Streaming!
Free music with your support on Patreon | Youtube: Music of Plexus Videos (music videos) | Youtube: Plexus Productions (audio related) Stop whining. Make music.
Free Streaming! Free music with your support on Patreon | Youtube: Music of Plexus Videos (music videos) | Youtube: Plexus Productions (audio related) Stop whining. Make music.