Hi all
I have an issue using the side chain with Melda MAutoDynamicEQ
The dynamics doesn't work with Reaper 7.07
It should work right ? Like in this video.
Any idea ?
Thanks
Repaer 7.07 - MAutoDynamicEQ
-
- KVRian
- 1241 posts since 25 Jan, 2017
That works fine here on 7.07.
Always check from the plugin routing (the pin connectors) if you're actually receiving the sidechain signal on the dedicated sidechain input, because that's an issue I've noticed with the sidechaining and track channel count on some plugins when "VST3 bus size" is set to Auto, which is by default.
You can either move the input pins of TrackChannel 3/4 in the correct spot (below the sidechan inputs), or simply change the "VST3 bus size" to '2' which auto-corrects that.
I don't remember exactly at which point REAPER had some changes in that department, which often lead to this.
Always check from the plugin routing (the pin connectors) if you're actually receiving the sidechain signal on the dedicated sidechain input, because that's an issue I've noticed with the sidechaining and track channel count on some plugins when "VST3 bus size" is set to Auto, which is by default.
You can either move the input pins of TrackChannel 3/4 in the correct spot (below the sidechan inputs), or simply change the "VST3 bus size" to '2' which auto-corrects that.
I don't remember exactly at which point REAPER had some changes in that department, which often lead to this.