Hey everyone,
I got chroma console and I'd like to run the audio from my DAW into the pedal and back into the DAW through the interface. I was able to do that successfully once before a few weeks ago but yesterday, I kept getting this pumping feedback in the lower frequenciies, even when no audio was playing. My signal chain was the audio from the DAW into the pedal's input and its output into line 1 of the interface. The track being recorded was muted so it would only record the audio I wanted it to record.
Any tips or suggestions are greatly appreciated. Thanks in advance.
Audio Signal Routing Help (Pedals and DAW)
-
- KVRer
- 24 posts since 31 Aug, 2022
-
- KVRAF
- 16866 posts since 8 Mar, 2005 from Utrecht, Holland
One thing to check: disable input monitoring in the DAW and/or audio interface control panel. Otherwise you'll get nasty feedback.
Other than that: I don't know. Just double-check cables and what signal goes where
Other than that: I don't know. Just double-check cables and what signal goes where
We are the KVR collective. Resistance is futile. You will be assimilated. 
My MusicCalc is served over https!!
My MusicCalc is served over https!!
-
Constructed Identity Constructed Identity https://www.kvraudio.com/forum/memberlist.php?mode=viewprofile&u=288890 - KVRian
- 1348 posts since 29 Sep, 2012 from Minnesota
I just had the same issue with my euro rack and it wasn't even getting an audio from the DAW..
What I think it is is extremely low frequencies (below what you can hear) in a feedback loop. You want to cut the send out of the feedback to zero and wait a bit because the waveforms are so long they take longer than you think to kill.
What I think it is is extremely low frequencies (below what you can hear) in a feedback loop. You want to cut the send out of the feedback to zero and wait a bit because the waveforms are so long they take longer than you think to kill.