Anyone with a Behringer Neutron that can check something for me?

[JO512]

I have a Behringer Neutron that had a couple of scratchy pots, the filter cutoff and the drive pots. I replaced them with new Alpha pots. I now notice some noise in the oscillators that I am not sure if was there previously. I patched directly from the OSC MIX to ATT 1 (attenuator 1) and directly out to my audio interface input to get as clean an oscillator signal as possible.

I have attached an audio file sweeping the sine wave from OSC1 and then switching to the saw and sweeping that a bit. Watch your ears! The saw is louder. Listen for the noise that becomes most apparent when the pitch is relatively high. I am wondering if this is normal. I don't remember hearing that much noise before, but I could be wrong. If you can, please set your oscillator pitch mode to the wide-range mode where all three LEDs are lit. And then sweep it up toward the higher range. I would greatly appreciate a comparison with your Neutron.