Does anyone know a way to control the amount of length on this parameter on a Remap from another modulator or macro or assign a midi knob or slider? Thanks
George
Phase Plant - Control Parameter Length with Macro or Midi knob_Phase Plant
-
- KVRist
- 389 posts since 9 Dec, 2014
Yes, in your example you are modulating oscillator shift (if I am not wrong).
So:
1. Try to assign a new modulation from, lets say, Macro 2, by clicking its (+) button.
2. Hover over oscillator shift parameter, and you will see that a yellow star is displayed.
3. Click on the start to modulate it.
So:
1. Try to assign a new modulation from, lets say, Macro 2, by clicking its (+) button.
2. Hover over oscillator shift parameter, and you will see that a yellow star is displayed.
3. Click on the start to modulate it.
-
- KVRer
- Topic Starter
- 5 posts since 18 Apr, 2025
Thanks for responding. Unfortunately that is not the solution. I am trying to control the length/amount of the parameter the arrow is pointing at. The Macro connected to the Yellow star would control the timing of the square wave. The parameter is modulating the Curve time but I want to flucuate that amount during performance instead of automating it though Slots.