KVR Audio

mr_smith · Post by **mr_smith** » Tue Jan 04, 2005 3:02 pm

i found an intresting thing:
when i redirect a channel (for example) from channel 1 to channel 2 in the mixer nothing happens. the sound coming out from channel 1.

config> 2GHz AMD, 1GB RAM, 4x 80GB HDD, Terratec DMX 6fire, latest ASIO driver for dmx

this is a new bug, in 4.5.1 it is worked fine.

also found that some vstps and vstis not working, whats worked in 4.5.1>
Yamaha VocalRack, Audiorealism Bassline 1.1 and so on.

what do you think?

Stupid American Pig · Post by **Stupid American Pig** » Tue Jan 04, 2005 3:06 pm

well, it works here. one thing to keep in mind- if the sounds has already started playing, and you change the mixer channel, it will not show up in the new channel until it has been retriggered. So if you have a long audio clip then you will need to either a) hit stop and then play again or b) just wait until the next time it is triggered.

mr_smith · Post by **mr_smith** » Tue Jan 04, 2005 3:09 pm

no its not working when stopped.

Stupid American Pig · Post by **Stupid American Pig** » Tue Jan 04, 2005 3:12 pm

hmmm- dunno what to tell ya- it works fine on my machine. I doubt that part of FL was even altered between 4.5 and 5.x. Have you tried the FL tech support forums?

mr_smith · Post by **mr_smith** » Tue Jan 04, 2005 3:15 pm

will try, but i like kvr better

what about the vst probz, did u found any?

Stupid American Pig · Post by **Stupid American Pig** » Tue Jan 04, 2005 3:17 pm

I dont have the Vsts you mentioned, so I dunno. I mainly just use Rhino, Sytrus, FPC, SFZ, and audio tracks.

speccyteccy · Post by **speccyteccy** » Tue Jan 04, 2005 4:24 pm

I've seen this problem when changing the fx channel of an audio clip - the change only takes effect when the song is restarted.

mr_smith · Post by **mr_smith** » Tue Jan 04, 2005 4:46 pm

its not working when i restart the tune. i will check this with the other soundcard (m-audio audiophile firewire) maybe its an asio prob.

Channel Routing in FLStudio 5.0.1