KVR Audio

jeffn1 · Post by **jeffn1** » Sat Apr 30, 2005 9:07 pm

I think I loaded up an impulse wave correctly (I got it from Noisevault) with the default factory settings (I did unpack the file--it is a stereo wave and it is recognized by Pristine Light).

I have it as an effect plug in on an audio track in Sonar that is associated with Kompakt (using Lyrical Distortion Guitars).

With PL bypassed, I can hear the samples. With PL in the chain, I do not hear anything.

I have no doubt I am missing something obvious. Any thoughts?

jeffn1

manytone · Post by **manytone** » Sat Apr 30, 2005 9:11 pm

Incorrect Latency settings can cause this.
Check the Manual for setting info.
Paul

jeffn1 · Post by **jeffn1** » Sat Apr 30, 2005 10:34 pm

manytone wrote:Incorrect Latency settings can cause this.
Check the Manual for setting info.
Paul

Thanks, Paul. I tried again and got it running.

jeffn1

Stupig Question Re Voxengo Pristine Light