Pitch Bendings

[brotherone]

When I do fast bendings with my pitch bend wheel and record it via midi it sounds right while recording.
But when I listen to it after recording it seems that the wheel doesn't go back to zero after a fast bending and the sound is just a little bit out of tune which sounds horrible with a cutting lead sound.
Has anyone else this problem too?
I'm using Sampletank 2.09 with Cubase SX3 and a Kurzweil K2661 mastercontroller.
Thanks

@Squids:
Just played the Sound from SonikSynth 2 >Bank A Synth->Synth Leads->018 Wake Up Man Ld and
recognized that when I hold a note in the range E4-A4 the sound just stops
after some time.
Is it not looped?
Is this a known problem and will it be fixed in the future?
Great lead sound by the way Squids


Best regards
Jochen

[Kim Lajoie]

When I do fast bendings with my pitch bend wheel and record it via midi it sounds right while recording.
But when I listen to it after recording it seems that the wheel doesn't go back to zero after a fast bending and the sound is just a little bit out of tune which sounds horrible with a cutting lead sound.
Has anyone else this problem too?
I'm using Sampletank 2.09 with Cubase SX3 and a Kurzweil K2661 mastercontroller.
Thanks

It sounds like there's something funny going on with your midi sequencer. Check the midi data that's recorded. Is there are midi message that sets the pitchbend value back to zero? It could be that it's being chopped off or something.

@Squids:
Just played the Sound from SonikSynth 2 >Bank A Synth->Synth Leads->018 Wake Up Man Ld and
recognized that when I hold a note in the range E4-A4 the sound just stops
after some time.
Is it not looped?
Is this a known problem and will it be fixed in the future?
Great lead sound by the way Squids

Hmm. I'm sure it'll be fixed soon. In the meantime, go to the synth settings and set the pitch to +24, and set the octave (to the right of the keyboard display) to -2. You can save those settings as a child preset if you want to use them later.

Hope that helps.

Forever,




Kim.

[brotherone]

Ok, so I have to wait for a sound update.

I'll check this midi issue, we will see...

Thanks for your reply Jeez!!!