When you create a new Part, changes to the channel controls (vol, pan, Mute, Solo) are not picked up until you close and re-open the part.
- happens both in the Seq and in the Audio part comp
BR Audio Part Editor - ignores channel controls first time
-
- KVRAF
- 10366 posts since 2 Sep, 2003 from Surrey, UK
I thought this had been fixed in one of the betas, but . . .
When you create a new Part, changes to the channel controls (vol, pan, Mute, Solo) are not picked up until you close and re-open the part.
- happens both in the Seq and in the Audio part comp
When you create a new Part, changes to the channel controls (vol, pan, Mute, Solo) are not picked up until you close and re-open the part.
- happens both in the Seq and in the Audio part comp
-
- KVRAF
- Topic Starter
- 10366 posts since 2 Sep, 2003 from Surrey, UK
-
- KVRAF
- 3948 posts since 8 Sep, 2003 from germany
confirmed , equally goes for coarse and fine pitch (couldn't really figure out what it takes to being recognized - playing through the whole song/loop once maybe ?).
m i d i - v s t (free)