TAL Software

Arovane · Post by **Arovane** » Tue Jan 12, 2021 11:42 pm

Hi
I own Bitwig and these nice two synths. Win7
When i switched through the Presets ....on many Presets the Cutoff or

Resonance move to another value when i press a key on my Midikeyboard.......can somebody confirm this ? Thank you in advance

Pinocchio · Post by **Pinocchio** » Wed Jan 13, 2021 8:44 am

Yes.
TAL J-8 Demo with Reaper 6.15 and Win7.
On some presets the RES slider is flickering.
Always at RES value of about 0.6 - 2.00

Arovane · Post by **Arovane** » Wed Jan 13, 2021 10:41 am

Thank you for confirming
I will send him a email about this

zerocrossing · Post by **zerocrossing** » Wed Jan 13, 2021 10:53 am

You’re probably sending it something from some outboard MIDI controller or synth. I have a Behringer FCB1010 and it was in a resting state but somewhat between values so it was bringing down the input gain on any record-armed channel. I have no idea why, as I have it set up so that it’s being routed to a specific track only.

ToguAudioLine · Post by **ToguAudioLine** » Thu Jan 14, 2021 1:24 am

Unfortunately some of the factory presets have a MIDI mapping assigned for the cutoff value.

You could try to record the MIDI data while the problem happens to see if your keyboard sends any MIDI data. I can imagine that it does if you are using an MPE or Aftertouch keyboard.

Please click MIDI CLEAR and enable MIDI LOCK in this case to make sure the plugin does not load any mappings from the presets.

Arovane · Post by **Arovane** » Thu Jan 14, 2021 3:11 am

IT WORKS NOW
Wonderful thank you for your great Products and great Support !!!
that was the solution :
Please click MIDI CLEAR and enable MIDI LOCK in this case to make sure the plugin does not load any mappings from the presets.

ToguAudioLine · Post by **ToguAudioLine** » Thu Jan 14, 2021 11:41 pm

Great to hear that it works now. To avoid problems like this we now removed the Midi Mappings from our factory presets:

https://tal-software.com/downloads/pres ... resets.zip

Please overwrite the factory presets in your presets folder if you want to get rid of the mappings.

Echoes in the Attic · Post by **Echoes in the Attic** » Sat Feb 20, 2021 10:41 am

ToguAudioLine wrote: ↑
Thu Jan 14, 2021 11:41 pm
Great to hear that it works now. To avoid problems like this we now removed the Midi Mappings from our factory presets:

https://tal-software.com/downloads/pres ... resets.zip

Please overwrite the factory presets in your presets folder if you want to get rid of the mappings.

Did you do this for the other synths and the sampler too?

TAL Software

KVR Audio

Bitwig 3.3.1. & TAL J-8 & TAL-U-NO LX ghostly Parameter move