KVR Audio

taussenac · Post by **taussenac** » Tue May 25, 2004 3:37 pm

Is it possible to code a VST plugin with two entries?
I mean, for example, a guitar and a voice at the same time?
Thanx, Thomas.

Phaedo · Post by **Phaedo** » Tue May 25, 2004 4:38 pm

Don't think it is (a weakness in the spec, that). It is possible to have a stereo plug-in take two mono sources panned hard-right and left. Or the same trick with a single surround input. But it's pretty nasty...

taussenac · Post by **taussenac** » Tue May 25, 2004 4:44 pm

Phaedo wrote:Don't think it is (a weakness in the spec, that). It is possible to have a stereo plug-in take two mono sources panned hard-right and left. Or the same trick with a single surround input. But it's pretty nasty...

Yes, that's exactly what I wanted to know.
My two imput signals are mono.
My plugin is already coded in C++ and works well.
Do you think the modifications will be hard to make?
Do you know where I can get some usefull informations about that?
Thomas.

Post by **Ben [KVR]** » Tue May 25, 2004 5:14 pm

[moved to the dev forum]

texture · Post by **texture** » Tue May 25, 2004 8:14 pm

You can have more than two inputs to a vst, but most hosts don't support it.

xoxos · Post by **xoxos** » Tue May 25, 2004 8:44 pm

there are a couple of 'send' fx plugs.. mixbag, senderella.. you might be able to fanangle a split stereo signal out of two separate monos with that, otherwise i usually just bounce an audio track down.

quincy · Post by **quincy** » Tue May 25, 2004 8:49 pm

2 entries, now you're talking....

ahem

2 entries VST plugin