is contol surface support planned for devices other than Makie?
Is this the type of thing that a (savvy) user could program?
Owner of a humble US-428 here
Steve
T2 Control surface support
-
- KVRist
- 169 posts since 10 Feb, 2003 from Melbourne, Australia
Hello there,
is contol surface support planned for devices other than Makie?
Is this the type of thing that a (savvy) user could program?
Owner of a humble US-428 here
Steve
is contol surface support planned for devices other than Makie?
Is this the type of thing that a (savvy) user could program?
Owner of a humble US-428 here
Steve
-
- KVRAF
- 6490 posts since 14 Jun, 2004 from Rochester, NY
Yup same here im on us428 and really expected some sort of way to use it
plz?
RonC
plz?
RonC
-
- KVRist
- 92 posts since 28 Feb, 2004
Well the Mackie Control is after all just a MIDI control surface, so it should be possible to find out what MIDI messages it sends to T2 and create a preset for any other control surface to emulate it. But unless there is a list of the MIDI messages somewhere on the web it requires a Mackie control unit to find them..