Is it possible to use the microKONTROL as a control surface in T2? If so, would you be kind enough to show me how?
Thanks!!!!
Lance
Korg microKONTROL and T2?
-
- KVRist
- 317 posts since 13 Mar, 2003 from San Diego
-
- The Teach
- 8273 posts since 23 Jul, 2002 from flatness
assuming the microkontrol connects via USB ...
... plugin it in ... switch it on ... fire up T2 ... click on the 'settings' tab and enable the microkontrol as a MIDI interface in the 'MIDI devices' section of the 'audio devices' page ...
... open or create an edit ...
(if 'per-track inputs' enabled) ... click a tracks input arrow and select the microkontrol as that tracks MIDI input from the drop-down list ...
(if 'per-track inputs' disabled) ... drag the little microkontrol arrow until it 'glues' the the track you want to play into ...
... if you want to set up controller mappings for the knobs and sliders ...
... connect up as previously described ... on the edit page click the 'automation' button (bottom-left) and select 'create MIDI controller mappings' ... click on the left and move as control then click on the right and select the parameter to be controlled ... repeat as necessary for other knobs / parameters ...
(remember though - controller mappings are saved on a per-edit basis so youll need to set these up seperately for each new edit)
slainte
rob
... plugin it in ... switch it on ... fire up T2 ... click on the 'settings' tab and enable the microkontrol as a MIDI interface in the 'MIDI devices' section of the 'audio devices' page ...
... open or create an edit ...
(if 'per-track inputs' enabled) ... click a tracks input arrow and select the microkontrol as that tracks MIDI input from the drop-down list ...
(if 'per-track inputs' disabled) ... drag the little microkontrol arrow until it 'glues' the the track you want to play into ...
... if you want to set up controller mappings for the knobs and sliders ...
... connect up as previously described ... on the edit page click the 'automation' button (bottom-left) and select 'create MIDI controller mappings' ... click on the left and move as control then click on the right and select the parameter to be controlled ... repeat as necessary for other knobs / parameters ...
(remember though - controller mappings are saved on a per-edit basis so youll need to set these up seperately for each new edit)
slainte
rob-
- KVRist
- Topic Starter
- 317 posts since 13 Mar, 2003 from San Diego
Thanks!