Level and pan filters stuck
-
- KVRian
- 652 posts since 1 Apr, 2005 from Illinois
I just installed the latest T2 version and now my default level and pan filters are stuck unless I delete them from their respective tracks and then assign them again. This is on a song with 20 audio tracks. Anyone else run ito this?
-
- KVRian
- Topic Starter
- 652 posts since 1 Apr, 2005 from Illinois
Not that I'm aware of. Where do you look to see? I went ahead and removed and replaced all of the Vol/Pan filters and that fixed it so far. And it is only on one song that I've noticed this happening. Weird. The song was a bunch of tracks that I bounced in from a Roland VS-1680. I wonder if somehow the 1680 sent fader and panning messages to T2 since I was using MMC to sync the two up. Hmmmm......AD80 wrote:I've never seen that happen before. Are you sure you dont have any hidden automation?
-
- KVRAF
- 3745 posts since 29 Sep, 2002 from Killafornia
Theres a little "a" on the top right corner of each track, you can view any active automation from there. Remember that automation from any plug-in can be put on any track, and also if one volume/pan filter has automation, and you copy the track, it'll also copy the automation. Maybe thats what happened 
Tip: If you right click on a vol/pan filter (or any plug-in) you can "select all filters of the same type". It'll make it easy to delete all of them at once if need be.
Tip: If you right click on a vol/pan filter (or any plug-in) you can "select all filters of the same type". It'll make it easy to delete all of them at once if need be.
-
- KVRian
- Topic Starter
- 652 posts since 1 Apr, 2005 from Illinois
Weird. It hasn't happened since I swapped all of them out. I must have bumped a key or something and didn't realize it. Not sure what else would cause that to happen. The advice on the "select all filters of the same type" is good. It's the little things like that that make life easier. Thanks for the help.