MIDI Controller activating short-cuts

[brookerb]

I'm having a difficult time getting my midi controller (EDIROL PCR-80) to work in T2.

I've read two threads in this forum and acted on all the information, and all my controller is doing is activating short cuts (turning looping on and off, toggling between the edit and the projects window)

I've selected an instrument vst, enabled end-to-end, triple checked my inputs and outputs, ensured the input icon is showing a keyboard (did this by turning off "per-track view for input devices" in options)

The level in the input icon isn't affected by hitting notes.

Anyone have ideas? The manual isn't giving me any clues.

Another important thing is my keyboard isn't showing up in the "External Controllers" panel in the "Settings" tab. Should it be there?

Thanks in advance.

[djsubject]

go to the settings page in tracktion then go to controll devices then set both controllers to none!!!!

then all will be dandy


Subject

[brookerb]

Thanks for the reply.

I did that, and now the icon is showing output, but i'm not hearing anything.

One thing I was wondering: I've got the midi out on my keyboard going to midi in on the card. Just one cable, which works in Cubase. For some reason or other, do I need two cables to operate a controller in tracktion?

[djsubject]

Thanks for the reply.

I did that, and now the icon is showing output, but i'm not hearing anything.

enable "end to end" by the transport controlls or press play & test again!

if it still dosent work you have not loaded the vsti "filter" properley!


load a demo tune & test it in there on a track with the MDA synth or Tracktion sampler loaded!


Good Luck


Subject

[brookerb]

Thanks djsubject! All is well. This forum is a great help!

[djsubject]

Thanks djsubject! All is well. This forum is a great help!

at last a happy customer

glad i could help

Subject

[Mr. Tingle]

brookerb - how do you get your controller to control the short cuts?

I've been trying to work this out and have no idea.

[djsubject]

brookerb - how do you get your controller to control the short cuts?

I've been trying to work this out and have no idea.

set it as the MCU controller in the settings page

but i wouldent reconmend using a keybord!

if you have a midi controller that can be programmed then you can set it to do some of the commands but not all


Subz

[Mr. Tingle]

that page gives the impression that only mackie products work, but I shall give it a shot.

[djsubject]

that page gives the impression that only mackie products work, but I shall give it a shot.

it is only mackie LC & MCU that work properley!!!


look here for more help

http://www.kvraudio.com/forum/viewtopic ... 02#1239802