initializing system falior?
-
- KVRist
- 106 posts since 26 Jul, 2005 from The Netherlands/Sweden
I have the Muse for a few moths now, and i like it. But yesterday i had played and put it out. Now i have started it up again, but it KEEPs into the Initializing system mode. For ours now. I can't find something in the manual about this. Does this mean it's cleaning my system???
-
- KVRist
- Topic Starter
- 106 posts since 26 Jul, 2005 from The Netherlands/Sweden
b.t.w. i did all resets with pushing the on/off knob twice and 3 times. Even holding it for 4 sec's didn't get the muse out of this mode!
-
- MUSEician
- 682 posts since 20 Aug, 2004 from California
Try holding the MULTI button down while it boots. If that does not work, can you connect a monitor to it? What does the monitor show?
Dan Timis
Software Developer
Muse Research, Inc.
Software Developer
Muse Research, Inc.
-
- KVRist
- Topic Starter
- 106 posts since 26 Jul, 2005 from The Netherlands/Sweden
thanks, but that didn't work. I got mail from Muse to disconnect everything and reboot again, but that failed as well. On my laptop i can't connect with the Muse software, but it can see the drive in network locatons. But the drive is unreachable, because of the initializing thing. Tomorrow i will connect a monitor to it.
-
- KVRist
- Topic Starter
- 106 posts since 26 Jul, 2005 from The Netherlands/Sweden
Everything is working fine again. Thanx to the very good support of the Muse team!