Minor Feature Request for Zebra

[Dunc]

Would it be possible to implement a numerical height figure in the MSEG's for the breakpoints.
I am finding it a bit troublesome to get a loop Start and End point at the same height so that a step in whatever the MSEG is modulating does not happen.

It would also be helpful for a similar numerical adjustment to be available for Tune in the Oscillators. The lowest I can seem to get 0.5 which is quite a lot in terms of detune between 2 oscillators.

EDIT: Sorry I'm blind and not thinking today, (too little sleep from playing with this) I didn't see the Detune Knob. However it would probably still be useful to be able to numerically change a value for a knob using a Computer keypad as well as the mouse.


Just ignore me if you already have plans in the pipe for these things.

Dunc

[Urs]

Hmmm... ah, yes, I see what you mean. I think I'll let it draw like a vertical line when loop start and loop end are at the same height. Something like that.

A numerical display may happen, too.

Regarding fine control, there's currently the option to hold [shift] when you click a knob. It's then set to fine control in 0.01 steps.

I see that latter is a bit tedious, having to use a modifier key everytime. I'm trying to figure out a concept like a "hot spot" in the knobs that automatically sets them to fine resolution when clicking.

Cheers,

Urs

[Dunc]

Thanks Urs for the reply.

I think I should stop bothering you for a while and go and get some sleep...zzz


Dunc

[Urs]

Thanks Urs for the reply.

I think I should stop bothering you for a while and go and get some sleep...zzz


Dunc

Haha, no prob. I think I'll take a nap, too. Have written at least 50 emails and 20 forum posts today. When will I have time to continue work, dammit

Cheers,

Urs