Tracktion Software

polaris20 · Post by **polaris20** » Fri Dec 16, 2005 8:27 pm

How do you enable VST's to be audible while you play? For example, T2 with Amplitube LE. I want to hear Amplitube's amp sounds while I am playing guitar into T2. I looked in the manual, and couldn't quite grasp it.

dry bones · Post by **dry bones** » Fri Dec 16, 2005 8:34 pm

Make sure end-to-end is enabled in the transport section and on the track info bar at the bottom

polaris20 · Post by **polaris20** » Fri Dec 16, 2005 8:46 pm

Are there any negative effects of doing this, besides the obvious increase in CPU useage?

jtxx000 · Post by **jtxx000** » Fri Dec 16, 2005 10:02 pm

nope, it just means that your signal goes from end to end... from the left inputs all the way through the filters and out the output on the bottom right.

polaris20 · Post by **polaris20** » Fri Dec 16, 2005 10:20 pm

jtxx000 wrote:nope, it just means that your signal goes from end to end... from the left inputs all the way through the filters and out the output on the bottom right.

That's ri-goddamn-diculously cool. I'ma ordering me some T2 tonight, with a Presonus Inspire 1394, which is both phantom-powered XLR's and guitar inputs. So I can jam on lunch, and lay some tracks.

dry bones · Post by **dry bones** » Sat Dec 17, 2005 9:45 am

Welcome to our world

mapper · Post by **mapper** » Sat Dec 17, 2005 9:03 pm

Ampltube LE and tracktion rocks out.!!
I've been using it for ages...had it before with T1..then they relaese it with T2..ah well..
just notch your latency down as far as you can get it and its a smooth as anything.
I use Racks to layer up with stuff like
Amplitube+a good tremelo+reverb+EQ.
you can get some great tones.
As good as the full amplitube ones for a fraction of the cost.
Radical Dude.

polaris20 · Post by **polaris20** » Mon Dec 19, 2005 11:18 am

dry bones wrote:Welcome to our world

Well, I've had T1.6 for a year now, but am finally jumping on the T2 bandwagon.

mychaleg · Post by **mychaleg** » Wed Dec 28, 2005 3:49 pm

polaris20 wrote:Are there any negative effects of doing this, besides the obvious increase in CPU useage?

just want to re-emphasize that you tweak your latency settings. depending on your system power you may get some underruns. mute any tracks you don't need to hear while end to end recording effects heavy tracks to take the burden off your resources.

Stairsteps · Post by **Stairsteps** » Wed Dec 28, 2005 4:01 pm

dry bones wrote:Welcome to our world

And the world of Sonar, Cubase and every sequencer on the planet lets you do this i thought. a very simple procedure.

Tracktion Software

KVR Audio

Realtime VST effect (hearing while playing)