KVR Audio

TotcProductions · Post by **TotcProductions** » Mon Jul 17, 2006 5:19 pm

Thanks for releasing this Fretted Synth!! It's got a permanent spot on my HD.

peace

FrettedSynth · Post by **FrettedSynth** » Mon Jul 17, 2006 6:05 pm

thecontrolcentre wrote: That explains it ... shame, i was looking forward to this (please post if you lose the SSE) the new version looks very tasty

I'll continue using V1.5 ... cheers

All hope is not lost to use v2.0 for you

I just sent a test version to be tested on linux No SSE, I think this might be part of the cause of FreeAmp not working on linux? not sure as I just got the first ever linux distro to see all my hardware "Musix" still will be some time before I run VST's on linux but sure gave me hope to run zynaddsubfx through Jack with less latency and crap then windows ever gave me running zyn

And thanks Ben (KVR), Front page news

Gotta love this site (I have followed it since it first showed up on the cubase webring many years ago). And thanks Totc and all others, I hope the future will bring much more to FreeAmp.

Fretted Synth

ouroboros · Post by **ouroboros** » Mon Jul 17, 2006 6:58 pm

Wow, thanks so much

I don't play guitar, so it took me a while to actually d/l and use this, but what a treat, thanks! It is wonderful on everything.

chrishurley · Post by **chrishurley** » Mon Jul 17, 2006 7:30 pm

Thanks for your hard work. The new look is very nice. I really like some of the clean sounds. I'm not too big on the dirty tones, but this is definately a must-have release for anyone that uses guitar plugins. Great job!

Moe Shinola · Post by **Moe Shinola** » Tue Jul 18, 2006 6:23 am

Thanks for the new amp! It sounds great and I've already recorded a guitar part for another musician with it. However, I haven't been able to get the synth section to work at all. I use S3PE and have tried both ASIO and WDM. It dosen't seem to make a diffrence. When you flick the "power" button on in the synth section the audio shuts off. Dial back the "mix" knob and it starts to come back , but dial in the synth and goodbye sound. Am I doing something wrong? Or is this another of Sonar's annoying shortcomings?

morelia · Post by **morelia** » Tue Jul 18, 2006 6:48 am

Thanks so much. I must admit I probably have guitar amp sim software overload on my computer but there is always rooms for more. Even though I use some of the market leaders amp sim products I know I will find a use for FreeAmp as it has fantastic quality. The GUI is also looking awsome with this release.

asseca · Post by **asseca** » Tue Jul 18, 2006 7:32 am

Moe Shinola wrote:I haven't been able to get the synth section to work at all. I use S3PE and have tried both ASIO and WDM. It dosen't seem to make a diffrence. When you flick the "power" button on in the synth section the audio shuts off. Dial back the "mix" knob and it starts to come back , but dial in the synth and goodbye sound. Am I doing something wrong? Or is this another of Sonar's annoying shortcomings?

AUDIO TRIGGERS
The AUDIO TRIGGERS determines how the synth's envelope gate will respond to an audio input! Should be set to low values for fast response (fast picking, leads), Higher values will yield more sustain. NOTE: these controls are mapped to continuous controller numbers and should be looked at as controls that can be used in real time to control how the envelopes gate respond to an input.

GATE knob - sets the Input Threshold that will trigger the synth's envelope gate
DECAY knob - sets the envelope gate's time to re-trigger

the easiest way to get sound out of this synth:

Click on "Synth Setup"
Set "AMPLIFIER" > "SUS" to maximum
Set "FILTER 1" > "HP" to minimum and "LP" to maximum
Vary "CUT" frequency ...

laputa_sync · Post by **laputa_sync** » Tue Jul 18, 2006 8:11 am

tried this out and it rocks!!!!
which presets do people use for bass, or am i not in the right forum, peace

asseca · Post by **asseca** » Tue Jul 18, 2006 9:48 am

laputa_sync wrote:tried this out and it rocks!!!!
which presets do people use for bass, or am i not in the right forum, peace

All the "Clean" presets which use PRE-COMPRESSOR and/or POST-COMPRESSOR should be usable for bass ...

laputa_sync · Post by **laputa_sync** » Tue Jul 18, 2006 12:11 pm

cheers, i am starting to really get into this beast. peace

Klemperer · Post by **Klemperer** » Tue Jul 18, 2006 12:26 pm

simply lovely, how great this amp works.

FrettedSynth · Post by **FrettedSynth** » Thu Jul 20, 2006 6:50 pm

Still no luck with linux it seems

Ain't giving up yet, will look a bit deeper into what could be the cause?

One thing I would be real curious about! Anyone out there have a Receptor ? That would be so kind to take the time to see if FreeAmp2 runs or not on Receptor?

Thanks
Fretted Synth

crazed one · Post by **crazed one** » Thu Jul 20, 2006 10:28 pm

Thanks again for FreeAmp2.

I read that some people were unable to get that extreme high gain out of this plug but all I know is that I'm thrashing with this thing! I like it a lot!

FrettedSynth · Post by **FrettedSynth** » Fri Jul 21, 2006 4:59 pm

crazed one wrote:Thanks again for FreeAmp2.

I read that some people were unable to get that extreme high gain out of this plug but all I know is that I'm thrashing with this thing! I like it a lot!

Cool, I take it you worked out direct through in cubase

Fretted Synth

crazed one · Post by **crazed one** » Fri Jul 21, 2006 5:59 pm

FrettedSynth wrote: Cool, I take it you worked out direct through in cubase

Fretted Synth

Sure did.

I had to uncheck a setting. I posted which one it was in the beta forum.

Fretted Synth Audio FreeAmp2 Released