Sylenth and CB4 ?

[DeepSync]

Hi again,

have u tested Sylenth with Cubase 4? Run ur Synth with the new VST 3.0 engine?

[Lennard]

I've not yet tested it myself on Cubase4, but Sylenth1 uses VST2.3 and I haven't heard of any problems with that in CB4. So I'm sure it will run just fine.

I'll try it as soon as I get the chance. If anyone else has already tried this, please confirm.

[DeepSync]

I ask because ARTURIA updated the CS80 and minimoog to Vst 2.4 \ Cubase 4 ready they write.

[4damind]

No problem here with the demo-version. Its working without problems in Cubase4.

[Lennard]

I ask because ARTURIA updated the CS80 and minimoog to Vst 2.4 \ Cubase 4 ready they write.

Then they might have used an older VST version before. There were some reported problems with VST2.0, but not with 2.3 or 2.4 (at least, not that I know of).

No problem here with the demo-version. Its working without problems in Cubase4.

Thanks for confirming! The demo version behaves exactly the same as the full version by the way.