Blue Cat Audio

JamieSkeen · Post by **JamieSkeen** » Thu Dec 28, 2006 9:55 pm

it will load with a horrible noise or it will act fine until playback stops and then that noise comes back....

Blue Cat Audio · Post by **Blue Cat Audio** » Thu Dec 28, 2006 9:59 pm

Hi,

thanks for the feedback. Did you try our other products (the freeware ones for example) in reaper? Do they have the same problem?

JamieSkeen · Post by **JamieSkeen** » Thu Dec 28, 2006 10:02 pm

the chorus and flanger are fine..

Blue Cat Audio · Post by **Blue Cat Audio** » Fri Dec 29, 2006 9:14 am

Ok thanks, we'll get a demo of Reaper and have a look. Which Parametr'EQ demo are you using? Mono, Stereo or Widening?

JamieSkeen · Post by **JamieSkeen** » Fri Dec 29, 2006 10:55 pm

mono & stereo

Blue Cat Audio · Post by **Blue Cat Audio** » Sat Dec 30, 2006 10:11 am

I just checked here, and even though I could not reproduce the horrible sound (I guess it's content dependent), I noticed that reaper does not call the suspend/resume routines of the VST plugins when you start/stop playing. This could be the reason why you have issues (and I bet you may have the same problem with other plugins), because that's where the filters are reset. If they are not, when you start playing again it may produce audible clicks or pops since it introduces a discontinuity in the audio signal.

From what I have checked, the DX version should work better within reaper. Could you try it to see if it solves your problem? (warning, when you install the directX version it does not show up in "DX" but "DXi" since our products support MIDI automation).

JamieSkeen · Post by **JamieSkeen** » Sat Dec 30, 2006 8:19 pm

ok thanks...I'll give the dx version a try

Blue Cat Audio · Post by **Blue Cat Audio** » Mon Jan 08, 2007 7:24 pm

Did it finally solve your problem?

Blue Cat Audio

KVR Audio

Problem with Parametr'EQ in reaper