Hey,
Zebra's an amazing synth, but I don't see an obvious way to assign a midi CC other than MIDI learn and it doesn't seem to respond to aftertouch from my Novation Remote. Am I missing something or is this not possible? I sure wish I could control cutoff freq with aftertouch...
Mark
Aftertouch assign?
-
- KVRAF
- 18446 posts since 26 Jun, 2006 from San Francisco Bay Area
-
- KVRian
- 864 posts since 4 Apr, 2001 from Finland
Sure you can. Select ATouch as a modulation source (by right clicking on the "...") for the filter (and turn the knob so that it affects). OR, set it up in the modulation matrix.
Also, are you sure that the Remote is sending Aftertouch - could be that it has been switched off on that side.
Also, are you sure that the Remote is sending Aftertouch - could be that it has been switched off on that side.