Hi,
I would like to know how I must used the aux 1 & 2 to have multi-outputs in eXT? (I can't assign the outputs in the synth mixer)
thanks in advance
DKS Pro + multi-outs
-
- DASH Guy
- 8160 posts since 20 Sep, 2001
Hi tekalo,
you should get more replies asking on the eXT forum, <grin>
or is it a DKS issue you have?!
you should get more replies asking on the eXT forum, <grin>
or is it a DKS issue you have?!
-
- KVRian
- 1372 posts since 21 May, 2004 from Serbia
You probably used sends in prefade mode to send individual sounds to aux outputs, with the mixer channel fader set to zero and fx turned off.
If you pan the sounds hard left/right and use the "inputs/outputs unlink" option in ext you can have 6 individual mono outputs
If you pan the sounds hard left/right and use the "inputs/outputs unlink" option in ext you can have 6 individual mono outputs
-
- DASH Guy
- 8160 posts since 20 Sep, 2001
thanks, are you using eXT 1 or 2?Branis wrote:You probably used sends in prefade mode to send individual sounds to aux outputs, with the mixer channel fader set to zero and fx turned off.
If you pan the sounds hard left/right and use the "inputs/outputs unlink" option in ext you can have 6 individual mono outputs
you could maybe post a template file for that DKS configuration in eXT, <grin>
-
- KVRian
- 1372 posts since 21 May, 2004 from Serbia
Here is a template for eXT 1.4
I noticed that ext ignores panning when the stereo channels are unlinked, so I included a stereo outs only version.
In this version you have 3 stereo outputs where you control the pans and levels of the sounds that are routed to AUXs from within the DKS mixer using send levels and pan sliders.
I noticed that ext ignores panning when the stereo channels are unlinked, so I included a stereo outs only version.
In this version you have 3 stereo outputs where you control the pans and levels of the sounds that are routed to AUXs from within the DKS mixer using send levels and pan sliders.
