u-he

groumpf · Post by **groumpf** » Sat May 12, 2007 3:04 pm

I have two tracks with a Zebra in both.
I make a MIDI learn on the part 1 volume knob for the first Zebra.
It works but the other Zebra in the other track also uses the same MIDI learn for the same knob.
Is it normal ? I mean why the MIDI learn is shared with all Zebra instances ?

I always found difficult to use such MIDI learn function, i would prefer a controller-number selection.

Actually I just want to use the volume controller but Zebra don't recognize it. Why ?

groumpf · Post by **groumpf** » Sun May 13, 2007 8:02 am

I found a workaround with using direct parameter automation on the Output. But this is a limitation (of all plug-ins I guess) because switching from a MIDI device to a plug-in in a track is not an easy task.

Urs · Post by **Urs** » Sun May 13, 2007 10:45 am

The MIDI CC support in my stuff will once be revamped... so that there'll be choices to do Midi learn just for a single instance, as well as organization of different midimappings for different purposes/setups.

For now it's just the ordinary and simple MidiLearn on global level, that is, shared among all instances.

Cheers,

Urs

groumpf · Post by **groumpf** » Sun May 13, 2007 10:58 am

Ok thanks,
actually I would much prefer a direct CC number selection than a MIDI learn, but it's your choice

Urs · Post by **Urs** » Sun May 13, 2007 11:31 am

groumpf wrote:actually I would much prefer a direct CC number selection than a MIDI learn, but it's your choice

Fair enough! - I'm thinking of a menu with entries like "1 - ModWheel" so that you can put them in like that