Blue Cat Audio

neilpullen · Post by **neilpullen** » Fri Jun 01, 2007 7:46 pm

Hi,

I'm having a bit of trouble with EQ bands in Ableton Live 6.0.7 with Parametr'EQ V3 mono. When I close a set, then go back into it the next day all the EQ bands are switched off by default -- the Gain/Freq/BW settings are still there as I set them but I have to manually open the Plug-in GUI and click "EQ Control: On". Is this a expected behaviour or am I doing anything wrong here?

Thanks!

Blue Cat Audio · Post by **Blue Cat Audio** » Sat Jun 02, 2007 7:37 am

Hi,

no, this is not the expected behavior. Do you have the same issue with the other plugins as well (Stereo and Widening)?

We will check this issue and include a bug fix in the next version(which should be released soon).

neilpullen · Post by **neilpullen** » Sat Jun 02, 2007 9:05 am

Thanks for the quick reply! I've tested the following:

ParametrEQ3 (Mono)
ParametrEQ3 (Stereo)
Stereo ParametrEQ3

I don't have the Widening EQ so I can't test this.

Funny thing is, the red light on the band to indicate a band is activated is red, but the sound doesn't act as if it's on until you click the "EQ Control: On". So it looks like the GUI is displaying correctly but it's the EQ filters that aren't on.

Blue Cat Audio · Post by **Blue Cat Audio** » Sun Jun 03, 2007 5:09 pm

Good news, we have a fix for the issue. The new version will be online very soon this week.

neilpullen · Post by **neilpullen** » Sun Jun 03, 2007 6:58 pm

Thanks very much, looking forward to the new version

Blue Cat Audio · Post by **Blue Cat Audio** » Mon Jun 04, 2007 8:43 pm

The new 3.1 is here!

neilpullen · Post by **neilpullen** » Tue Jun 05, 2007 6:11 pm

Just tested it, works perfectly -- thank you!

Blue Cat Audio · Post by **Blue Cat Audio** » Tue Jun 05, 2007 8:24 pm

You are welcome! Thanks again for your feedback.

Blue Cat Audio

KVR Audio

Ableton and Parametr'EQ 3 Mono