Setting up Receptor to work with Logic Pro

[killertom]

Is there any documentation to support setting up Logic to run Receptors instruments using Uniwire? It's not the same as Cubase that's for sure as I've instantiated a MUSE instrument but I'm not sure how to get the MIDI into it active?

Also like someone else on this forum I've noticed the Receptor randomly lose connection with the host sequencer for no reason at all (using crosstalk with appetalk).

[killertom]

Anyone?

[MCal]

Hi. I've had best luck by using windows networking rather than Appletalk which is a slower protocol. Also is your mac online or networked via say airport as well as having the connection to the Receptor via ethernet? this has caused me problems, so disable all other networking if there is any. what type of mac are you running this on?

Al.

[killertom]

I actually (not for the first time) was an idiot. The problem was the receptor had crashed out and therefore (although remote was working) and therefore MIDI and audio weren't being routed on the instrument channel. Thanks for thr advise on windows networking working faster (although I had plug authorisation issues when not using appletalk).

Incidentally is there a Muse mulit-channel instrument in Logic or do you have to set up separate instruments for each channel (of a multichannel instrument)?

[MCal]

For Audio instruments such as uniwire you need to open up an instrument for every receptor plugin you wish to access, so I dont think their would be any advantage in attempting to route this through one of Logic's multi's.

Al.

[killertom]

By I'm only accessing one plug-in receptor (say for example Kontakt where the are 16 channels within the one plug-in). If I change the midi channel of the Logic instrument for a single given instrument it will access each plug-in channel - so how do I setup a multi-instrument to access all 16 channels?